waterproof case for wire-out electronics – Large (the ‘Connected Electronics’ case)

$89.95

When a wireless connection isn’t possible, this case allows you to stay plugged in whilst protecting your equipment from immersion.

(code 558)

You can either order direct from Aquapac by using ‘Add to cart’ below or, if you prefer, you can

SKU: 558 Category:

Description

Aquapac Connected Electronics waterproofs around a wire 558 rear view
rear view

This case is designed for electronics which require a thin wire to be connected to them at all times.

The special wire-thru clamp at one end allows that wire to stay connected, and be waterproof.
The case is usually used by professionals with specialist electronic devices, but could be used for a permanently connected small tablet, large phone or audio player.

Key Features
  • Use all buttons and switches through the case
  • Like most of our cases it’ll float if you drop it in the drink.
  • Feed out a wire of up to 2.5mm diameter from the case
  • The seams are high-frequency welded to form a super-strong bond.
  • Waterproofness Warning!: This case features our ‘TC’ Aquaclip which makes the case waterproof to IPX6 (a quick dunking should be fine, but not prolonged immersion).

Belt Loop
The loop on the back of the case is where you insert the belt.


This is the maximum size of device that will fit:

dimensions drawing

Tip: to get the circumference, add the width to the depth and then multiply this by 2


How waterproof is it?
IPX6 waterproofing level
It’s Stormproof (protected against powerful water jets – click on the icon for more)

PVC-Free


Color
Cool gray with gray belt and acid green lanyard

Materials
300mu UV-resistant TPU

Weight
Case: 3.1oz / 87g
Belt: 2.1oz / 59g
Lanyard: 0.2oz / 7g

Country of Origin
Made in the UK.

(code 558)


Special Instructions for the ‘TC’ Clamp

To Open

instructions diagram
click to expand
  1. Flip the two levers up, one at a time.
  2. Twist the two levers out.

To Close

  1. Place the wire carefully under the retaining arm. The wire must exit through the groove in the clamp.
  2. Place the two halves of the clamp back together so that the wire is held gently in place. Do not squeeze them together hard.
  3. Twist both the levers in, one at a time. Twist both levers before attempting step 6.
  4. Flip the levers over to seal the clamp.

Important Notes

Cases with this clamp are for surface use only, but will offer protection from temporary submersion. They are not recommended for prolonged submersion.

When not using the case leave the TC clamp open. If not the wire could eventually cause a permanent distortion of the foam, risking leakage.

As long as you follow this instruction the clamp will be watertight with or without a wire.

The maximum thickness of wire around which the TC clamp will seal is 1/10th inch (2.5mm).

 


Reviews

  1. Kelley, CA, USA

    I have the 558 and a 158 and they are both great products.

Add a review

Your email address will not be published.

WordPress spam blocked by CleanTalk.